Installation Sheet

November 20, 2018

10 of 12

SECTION 3

Stay Clip 1

Fig. 6a

Fig. 6b

a. Build this section using the 45° Hubs labeled Section 3 in the Hubs box, and Connecting Arms from the Section 3 box.

b. Start by connecting the E6 Arm to a Linear Hub (3a) then pass this arm through Stay Clip 1 until the arm end is approx. 2”

from the clip (Fig. 6b), refer to instructions on page 6. Continue by connecting a C9 Arm to the Linear Hub (3a), followed by

a 45° Hub (3b).

c. Add the remaining Arms and Hubs following the order and pattern in Fig. 6a, and complete this Section by joining the C2

Arm onto the 45° Hub (2c) on Section 2.

d. If necessary, adjust the position of Stay Clip 1 by loosening the set screw. Tighten the screw to complete this section.

3¼" (1)

11¼" (3)

16½" (1)

Arm Length Key

IMPORTANT:

Be sure to install all

M2 Set Screws to secure

the Arms to the Hubs,

as shown on page 6.

START

HERE