Installation & Assembly

2 of 2

November 14, 2019

Assembly Instructions

INSTRUCTIONS D’INSTALLATION

Keel Series - 44" and 60" LED Pendant

Important

• Always disconnect the power before installing or replacing bulbs and before cleaning or other maintenance.

• Consult a qualied, licensed electrician to ensure correct branch circuit conductor.

Consulter un électricien qualié pour vous assurer que les conducteurs de la dérivation sont adéquats.

1. Shut o power to the outlet box (A).

2. Determine height at which the pendant is to be hung. Use the

screwdriver to loosen the slotted set screw (E). Adjust height of cord.

Tighten the set screws to set. Reserve extra cord in the canopy (D). If eld shortening of

the cord is necessary, see Appendix A

3. Make appropriate electrical connections using wire nuts. :

a. Connect the LED driver’s (B) live wire (black) to the live outlet box wire.

b. Connect the LED driver’s (B) neutral wire (white) to the neutral outlet box wire.

c. Connect the canopy's ground wire (green or uncoated) to the ground outlet box wire. If no ground is present

in outlet box, connect canopy's ground wire to the mounting plate (C) using the green screw (included).

d. Connect the xture inner conductor to the red driver output wire and connect the xture outer conductor to the black

driver output wire.

e. Carefully place connections and LED driver in outlet box. (For 3828- Carefully place connections ansd LED driver in canopy.)

4. Attach the mounting plate (C) to the outlet box (A), secure with outlet box screw (F).

5. Attach canopy (D) to the mounting plate (C), secure with screws (G).

6. Install the mounting bracket (K) to the ceiling with anchor (L) and screw (J), then screw the post (H) onto the mounting

bracket. Adjust the steel cable (M) to level the xture (N). To shorten the cable, push the cable up; to lengthen, push in the

plunger while pulling down on the cable, release the plunger to lock.

7. Restore power to the outlet box (A).

Note

• The outlet box must be at least 4” DIA and 1.5” deep to t the LED driver.

• 3826- This xture is dimmable with Electronic Low Voltage (Trailing-Edge) type dimmers and Incandescent (Leading-

Edge) type dimmers.

• 3828- This xture is dimmable with electronic Low Voltage (trailing-Edge) type dimmers, Incandescent (leading-

Edge), and 0-10V type dimmers only.

Care Instructions

• Dusting: Use a clean, dry cloth.

• Cleaning: To protect the nish, avoid any harsh abrasives or chemicals.

3826, 3828

3828

3826