AT&T User Guide

46
USING APPLICATIONS
3. Tap on Options ( ) > Scan to scan all the
stations. Available channels are displayed.
4. Tap on Start Recording to record the audio
which is broadcasted on the radio to listen to the
same later.
5. Tap on Stop Recording to stop the audio
recording.
6. Tap on Options ( ) > Setting and the following
options are displayed:
• Regional Band: The regional band with frequency
range is displayed.
• Channel Spacing:
• Lower Freq Limit (in Mhz)
• Higher Freq Limit (in Mhz)
• Audio Output Mode: Select any of the following
options as a output mode: Stereo or Mono
• Alternate Frequency: Check this option to enable/
disable the auto selection of alternate frequency.
• Record Duration: You can set the time duration for
recording in the following time frame:
• 5 minutes
• 15 minutes
• 30 minutes
• Until stopped
• Revert to Factory Defaults: This option deletes all
the settings including Presets. Select OK to conrm.
7. Tap on Sleep. You can turn off the radio after a
selected time frame:
• 15 minutes
• 30 minutes
• 45 minutes
• 1 Hour
8. Tap on All Channels. The available channels/
stations are displayed with the station serial
number. For example, rst station in the list is
displayed as Station:1.
• Long tap on the required station/channel and the
following options are displayed:
• Station #: Each station/channel is given a serial
number in the list.
• Tune: You can tune to a different station/channel.
• Replace: You can replace the station/channel.
• Rename: You can rename the station/channel
name.
• Delete: A conrmation message is displayed
to delete the selected channel/station. Tap on
Delete and the channel/station is deleted form the
list.
Side Connector