User Guide

20
Make calls
Call barring
You can set Call barring facility for outgoing calls, interna-
tional calls, local calls and all incoming or roaming incoming
calls.
1. To set Call barring settings select Menu > Settings
Call settings > OK > Call barring > OK.
2. Enter a restriction password. (Your network operator
provides this before you use this function). This pass-
word will be sent to the network for verification.
 Cancel barring: when you cancel the call barring
facility you are prompted to enter a restriction pass-
word again. If the password is correct, your phone will
contact the network to disable this function.
 Barring status: when you check the status, your
phone will send a request to the network and the feed-
back will be displayed on your screen.
Call waiting
This facility can be used for GSM calls.
GSM calls
When Call waiting is enabled or turned on and your phone
is in conversation, the message Call waiting from... is dis-
played when you receive an incoming call.
1. To enable call waiting facility, select Menu > Settings
> Call settings > Call waiting > GSM call > On >
OK.
2. To cancel the call waiting facility, select Menu > Set-
tings > Call settings > Call waiting > GSM call >
Off > OK. You will not be prompted when you receive
an incoming call while your phone is busy. The caller
will receive a busy signal.
3. To verify the call waiting status, select Menu > Set-
tings > Call settings > Call waiting > GSM call >
Status.
GPRS calls
If the call waiting facility is enabled and you receive a GSM
call while you are in a GPRS session (for example browsing
the Net via the WAP service), the number of the caller is
displayed on your phone. You can choose to accept or reject
the call. If you accept the GSM call, the WAP session closes.
If you reject the incoming call, you continue with the WAP
session.
1. To set Call waiting facility select Menu > Settings >
Call settings> OK > Call waiting > GPRS Call >
OK > On/Off > OK.
Auto redial
When enabled, your phone will automatically redial within a
set interval, if a call does not connect.
1. To enable this function select Menu > Settings >
Call settings > Auto redial > On.
OR