Manual
Table Of Contents
- Analogue Redbox User Handbook rev 1.92
- Contents
- Figures
- Warranty, Safety & Installation Information
- RB-MA1 Single & RB-MA2 Dual Microphone Amplifiers
- RB-SM1 Single & RB-SM2 Dual Stereo To Mono Converter
- RB-UL1 Single, RB-UL2 Dual & RB-UL4 Quad Stereo Unbalanced
- RB-LU4 Quad Stereo Balanced To Unbalanced Converter
- RB-BL2 Single & RB-BL4 Dual Bi-Directional Matching Converte
- RB-SL2 Twin Mono, or Stereo, Limiter
- RB-DA6 6 Way Stereo Distribution Amplifier
- RB-HD1 Stereo Headphone Amplifier
- RB-HD6 6 Way Stereo Headphone Distribution Amplifier
- RB-SD1 Silence Detection Unit
- RB-PMX4 10 Input, 4 Output Analogue Preset Mixer
- RB-LI2 Stereo Line Isolation Unit
- RB-PLI6 6 Way Mono Passive Line Isolation Unit
- RB-SS10 10 Way Stereo Analogue Source Selector/Mixer
- RB-LC3 3 Way Light/Power Controller
- Glossary
- Connectors And Cabling
- Index
Chapter 15 - RB-LC3 3 Way Light/Power Controller
15-6 Redbox User Handbook
The available settings for output 3, configured using switches Sw9 to Sw12, are
detailed below:
Setting
No
Sw9 Sw10 Sw11 Sw12 Description
1 Off Off Off Off Flash Output 3 when telephone rings
Output 3 On when telephone is off-hook
2 On Off Off Off Output 3 On when telephone is off-hook
3 Off On Off Off Flash Output 3 when telephone rings
4 On On Off Off Output 3 On when Remote 1 asserted
5 Off Off On Off Output 3 On when Remote 2 asserted
6 On Off On Off Output 3 On when Remote 3 asserted
7 Off On On Off Flash Output 3 when Remote 1 asserted
8 On On On Off Flash Output 3 when Remote 2 asserted
9 Off Off Off On Flash Output 3 when Remote 3 asserted
10 On Off Off On Output 3 On when Remote 1 or Remote 2
asserted
11 Off On Off On Output 3 On when Remote 1 asserted
and Remote 2 not asserted
12 On On Off On Output 3 On when Remote 1 not
asserted and Remote 2 asserted
13 Off Off On On Output 3 On when Remote 1 asserted
and Remote 2 asserted
14 On Off On On Reserved for future assignment
15 Off On On On Latching Mode selection for Output 3
16 On On On On Momentary Mode selection for Output 3
Fig 15-6: Output 3 Configuration Settings
15.3.5. Flash Rate Preset Potentiometer
This preset potentiometer sets the rate at which the mains output is switched on/off
when one of the Flash Output settings is selected. The range of adjustment is from
0.5 seconds to 2 seconds.