Manual
Table Of Contents
- Analogue Redbox User Handbook rev 1.92
- Contents
- Figures
- Warranty, Safety & Installation Information
- RB-MA1 Single & RB-MA2 Dual Microphone Amplifiers
- RB-SM1 Single & RB-SM2 Dual Stereo To Mono Converter
- RB-UL1 Single, RB-UL2 Dual & RB-UL4 Quad Stereo Unbalanced
- RB-LU4 Quad Stereo Balanced To Unbalanced Converter
- RB-BL2 Single & RB-BL4 Dual Bi-Directional Matching Converte
- RB-SL2 Twin Mono, or Stereo, Limiter
- RB-DA6 6 Way Stereo Distribution Amplifier
- RB-HD1 Stereo Headphone Amplifier
- RB-HD6 6 Way Stereo Headphone Distribution Amplifier
- RB-SD1 Silence Detection Unit
- RB-PMX4 10 Input, 4 Output Analogue Preset Mixer
- RB-LI2 Stereo Line Isolation Unit
- RB-PLI6 6 Way Mono Passive Line Isolation Unit
- RB-SS10 10 Way Stereo Analogue Source Selector/Mixer
- RB-LC3 3 Way Light/Power Controller
- Glossary
- Connectors And Cabling
- Index
Chapter 14 - RB-SS10 10 Way Stereo Analogue Source Selector/Mixer
14-4 Redbox User Handbook
14.4. Rear Panel Connections and Operation
Fig 14-4 : RB-SS10 Rear Panel
14.4.1. Inputs
Four of the analogue audio inputs are on XLR-3 pin sockets (female) so that they can
be used for equipment which you may want to plug/unplug on a regular basis and
isn’t pre-wired, e.g. portable recorders.
The four XLR-3 inputs can take balanced professional levels, or unbalanced by using
the front panel gain controls, and by connecting the non-phase to the signal ground.
They have the following connections:
Pin 1: Screen
Pin 2: Phase
Pin 3: Non-phase
14.4.2. Outputs
The two XLR 3 pin outputs are electronically balanced, and can be wired unbalanced.
Each output is individually buffered so that a short circuit on one output will not affect
the others. They have the following connections:
Pin 1: Screen
Pin 2: Phase
Pin 3: Non-phase
14.4.3. Altering the Master Output Level
When the Output Level Control push-switch is Enabled (pushed in) on the rear panel,
it changes the functionality of the front panel volume control to also alter the level of
the master output, as well as the headphone volume.
Disconnect the mains supply before removing the equipment covers.
This product must be earthed
L
REMOTE START I / O
OUTPUT
115V - 230V
INPUTS 3 - 6
INPUTS 7 - 10
INPUT 2INPUT 1
OUTPUT
LEVEL CONTROL
RRRLL
ENABLE
DISABLE
REMOTE SELECT & SWITCH INPUTS
STATUS OUTPUTS
14.4.2 14.4.114.4.3
14.4.4 14.4.6
14.4.514.4.7