Manual
Table Of Contents
- Analogue Redbox User Handbook rev 1.92
- Contents
- Figures
- Warranty, Safety & Installation Information
- RB-MA1 Single & RB-MA2 Dual Microphone Amplifiers
- RB-SM1 Single & RB-SM2 Dual Stereo To Mono Converter
- RB-UL1 Single, RB-UL2 Dual & RB-UL4 Quad Stereo Unbalanced
- RB-LU4 Quad Stereo Balanced To Unbalanced Converter
- RB-BL2 Single & RB-BL4 Dual Bi-Directional Matching Converte
- RB-SL2 Twin Mono, or Stereo, Limiter
- RB-DA6 6 Way Stereo Distribution Amplifier
- RB-HD1 Stereo Headphone Amplifier
- RB-HD6 6 Way Stereo Headphone Distribution Amplifier
- RB-SD1 Silence Detection Unit
- RB-PMX4 10 Input, 4 Output Analogue Preset Mixer
- RB-LI2 Stereo Line Isolation Unit
- RB-PLI6 6 Way Mono Passive Line Isolation Unit
- RB-SS10 10 Way Stereo Analogue Source Selector/Mixer
- RB-LC3 3 Way Light/Power Controller
- Glossary
- Connectors And Cabling
- Index
Chapter 14 - RB-SS10 10 Way Stereo Analogue Source Selector/Mixer
Redbox User Handbook 14-1
14. RB-SS10 10 Way Stereo Analogue
Source Selector/Mixer ……
14.1. Introduction
Fig 14-1: RB-SS10 Front Panel
The RB-SS10 10 Way Stereo Analogue Source Selector/Mixer is a 1U rack-mount unit
that produces a stereo analogue audio output from 10 selectable stereo analogue
sources. There are 10 illuminated front panel push buttons, which select and indicate
the current channel selection. The selection and indication is also available through a
remote connector on the rear panel. To stop accidental front panel selection there is a
remote input to inhibit the front panel buttons.
As well as being able to act as a source select module, the RB-SS10 can act as a
mixer, by enabling the mix mode (using the remote input).
The gain for left and right inputs can be individually adjusted by using the preset
potentiometers on the front panel.
As well as routing the selected audio signal, the unit will also route a remote signal
input through the remote connector to the selected input source, for starting external
audio equipment such as a CD player.
The front panel headphone output has its own volume control, which is independent
of the level adjustment for the main outputs, and has a maximum output level of
+12dBu. The volume control can be made to also alter the output level of the main
XLR outputs by using a switch on the rear panel to enable/disable this feature.
There is a designation strip on the front panel, useful for giving the buttons a
meaningful description. The strip covers the input gain controls so that once
configured, they can’t easily be altered – ideal for installation work.
The LED on the front panel is used to indicate that power is present on the unit.
LEVEL
RB-SS10
ANALOGUE SOURCE SELECT
HEADPHONES
1 107
9
86
5
4
32