Manual
Table Of Contents
- Analogue Redbox User Handbook rev 1.92
- Contents
- Figures
- Warranty, Safety & Installation Information
- RB-MA1 Single & RB-MA2 Dual Microphone Amplifiers
- RB-SM1 Single & RB-SM2 Dual Stereo To Mono Converter
- RB-UL1 Single, RB-UL2 Dual & RB-UL4 Quad Stereo Unbalanced
- RB-LU4 Quad Stereo Balanced To Unbalanced Converter
- RB-BL2 Single & RB-BL4 Dual Bi-Directional Matching Converte
- RB-SL2 Twin Mono, or Stereo, Limiter
- RB-DA6 6 Way Stereo Distribution Amplifier
- RB-HD1 Stereo Headphone Amplifier
- RB-HD6 6 Way Stereo Headphone Distribution Amplifier
- RB-SD1 Silence Detection Unit
- RB-PMX4 10 Input, 4 Output Analogue Preset Mixer
- RB-LI2 Stereo Line Isolation Unit
- RB-PLI6 6 Way Mono Passive Line Isolation Unit
- RB-SS10 10 Way Stereo Analogue Source Selector/Mixer
- RB-LC3 3 Way Light/Power Controller
- Glossary
- Connectors And Cabling
- Index
Chapter 6 - RB-SL2 Twin Mono, or Stereo, Limiter
Redbox User Handbook 6-1
6. RB-SL2 Twin Mono, or Stereo, Limiter
6.1. Introduction
Fig 6-1: RB-SL2 Front Panel
The RB-SL2 is a stereo, or twin independent mono, VCA limiter for use in news-rooms
and other locations where the correct level into recording equipment is required, but
not necessarily under the control of an engineer, for example, for overload protection.
It can also be used as an inexpensive main output limiter for low cost radio
installations, RSL’s, hospital and student radio.
The XLR-3 electronically balanced inputs and outputs can be wired unbalanced to
accept an output from domestic equipment. For each channel there is an input gain and
a threshold level control.
A rear panel switch changes the unit from dual mono to stereo, when only the pre-sets
for channel 1 (left) are active and apply to both channels. An LED power indicator on
the front panel displays the power supply connection.