Manual
Table Of Contents
- Analogue Redbox User Handbook rev 1.92
- Contents
- Figures
- Warranty, Safety & Installation Information
- RB-MA1 Single & RB-MA2 Dual Microphone Amplifiers
- RB-SM1 Single & RB-SM2 Dual Stereo To Mono Converter
- RB-UL1 Single, RB-UL2 Dual & RB-UL4 Quad Stereo Unbalanced
- RB-LU4 Quad Stereo Balanced To Unbalanced Converter
- RB-BL2 Single & RB-BL4 Dual Bi-Directional Matching Converte
- RB-SL2 Twin Mono, or Stereo, Limiter
- RB-DA6 6 Way Stereo Distribution Amplifier
- RB-HD1 Stereo Headphone Amplifier
- RB-HD6 6 Way Stereo Headphone Distribution Amplifier
- RB-SD1 Silence Detection Unit
- RB-PMX4 10 Input, 4 Output Analogue Preset Mixer
- RB-LI2 Stereo Line Isolation Unit
- RB-PLI6 6 Way Mono Passive Line Isolation Unit
- RB-SS10 10 Way Stereo Analogue Source Selector/Mixer
- RB-LC3 3 Way Light/Power Controller
- Glossary
- Connectors And Cabling
- Index
Chapter 1 - RB-MA1 Single & RB-MA2 Dual Microphone Amplifiers
1-4 Redbox User Handbook
1.4. Technical Specifications
1.4.1. Audio Specifications
Maximum Input Level: -10dBu
Maximum Output Level: +28dBu
Input Impedance: 20kΩ nominal balanced
Output Impedance: <50Ω
Low Frequency Roll-Off: 125Hz @ 6dB/octave
Gain Range: Adjustable 36dB to 75dB gain
E.I.N: 130dB
Distortion: 0.01% THD @ 1kHz, ref +8dBu output
Common Mode Rejection: >66dB typically
Phantom Power: 48V
Frequency Response: 20Hz to 20kHz ±0.1dB (600Ω load, ref 1kHz)
1.4.2. Connections
Input: 1 (2 on RB-MA2) x XLR 3 pin female (Balanced)
Output: 1 (2 on RB-MA2) x XLR 3 pin male (Balanced, can be
unbalanced)
Mains Input: Filtered IEC, 110V-120V, or 220-240V switchable, fused,
6W maximum
1.4.3. Equipment Type
RB-MA1: Single microphone amplifier
RB-MA2: Dual microphone amplifier
1.4.4. Physical Specifications
Dimensions (Raw): 28cm (W) x 10.8cm (D) x 4.2cm (H) (1U)
Dimensions (Boxed): 36cm (W) x 20.5cm (D) x 6cm (H)
Weight RB-MA1: Nett: 0.90kg Gross: 1.35kg
Weight RB-MA2: Nett: 1.00kg Gross: 1.45kg