Manual
Table Of Contents
- Analogue Redbox User Handbook rev 1.92
- Contents
- Figures
- Warranty, Safety & Installation Information
- RB-MA1 Single & RB-MA2 Dual Microphone Amplifiers
- RB-SM1 Single & RB-SM2 Dual Stereo To Mono Converter
- RB-UL1 Single, RB-UL2 Dual & RB-UL4 Quad Stereo Unbalanced
- RB-LU4 Quad Stereo Balanced To Unbalanced Converter
- RB-BL2 Single & RB-BL4 Dual Bi-Directional Matching Converte
- RB-SL2 Twin Mono, or Stereo, Limiter
- RB-DA6 6 Way Stereo Distribution Amplifier
- RB-HD1 Stereo Headphone Amplifier
- RB-HD6 6 Way Stereo Headphone Distribution Amplifier
- RB-SD1 Silence Detection Unit
- RB-PMX4 10 Input, 4 Output Analogue Preset Mixer
- RB-LI2 Stereo Line Isolation Unit
- RB-PLI6 6 Way Mono Passive Line Isolation Unit
- RB-SS10 10 Way Stereo Analogue Source Selector/Mixer
- RB-LC3 3 Way Light/Power Controller
- Glossary
- Connectors And Cabling
- Index
Warranty, Safety & Installation Information
Redbox User Handbook v
Fitting Redboxes
Redboxes can be fixed to the underside of a mixing desk, or other surfaces using 2 off
No. 6 countersink screws.
They can also be rack-mounted, with either the front, or rear of the Redbox
positioned at the front of the rack:
Front Mounting Redboxes: For rack mounting smaller (28cm) units the optional
RB-RK1 (Red) or RB-RK1B (Black) kit can be used (which include 4 off M6 panel
fixing screws).
Fig W-2: RB-RK1(B) Small Redbox Front Rack-mount Kit
Rear Mounting Redboxes: For rear panel mounting you can use either the RB-RK2,
or RB-RK3, depending on the size of your Redbox.
RB-RK2 1U rear panel rack kit for small Redbox range, e.g., RB-BL2
Fig W-3: RB-RK2 Small Redbox Rear Rack-mount Kit
e.g. for fitting an RB-BL2:
RB-RK3 1U rear panel rack kit for large Redbox range, e.g., RB-DA6
Fig W-4: RB-RK3 Large Redbox Rear Rack-mount Kit
e.g. for fitting an RB-DA6: