Manual
Table Of Contents
- Contents
- Figures
- Warranty
- Safety Information
- 1 RB-UL1 Single, RB-UL2 Dual & RB-UL4 Quad Stereo Unbalanced To Balanced Converters
- 2 RB-LU4 Quad Stereo Balanced To Unbalanced Converter
- 3 RB-BL2 Single & RB-BL4 Dual Bi-Directional Matching Converter
- 4 RB-PA2 Dual Stereo RIAA Phono Amplifier
- 5 RB-LI2 Stereo Line Isolation Unit
- 6 RB-PLI6 6 Way Mono Passive Line Isolation Unit
- 7 RB-DA6 & RB-DA6G 6 Way Stereo Distribution Amplifier
- 8 RB-DA4x5 4 Input 4 x 5 Output Distribution Amplifier/Mixer
- 9 RB-DDA6A 6 Way Stereo AES/EBU Digital Distribution Amplifier and RB-DDA6S 6 Way Stereo S/PDIF Dig
- 10 RB-DDA6W 6 Way Word Clock Distribution Amplifier
- 11 RB-HD1 Stereo Headphone Amplifier & RB-HD2 Dual Headphone Amplifier
- 12 RB-HD6 6 Way Headphone Distribution Amplifier
- 13 RB-DHD6 Digital 6 Way Headphone Distribution Amplifier
- 14 Connectors & Cabling
- Glossary
Redbox User Handbook No 2
v
They can also be rack-mounted, with either the front, or rear of the Redbox positioned at the
front of the rack:
Front Mounting Redboxes: For rack mounting smaller (28cm) units the optional RB-RK1
(Red) or RB-RK1B (Black) kit can be used (which include 4 o M6 panel xing screws).
Fig D: RB-RK1Small Redbox Front Rack-mount Kit .
Wherever you see this symbol an RB-RK1 front panel rack kit can be used :
Rear Mounting Redboxes: For rear panel mounting you can use either the RB-RK2, or
RB-RK3, depending on the size of your Redbox.
RB-RK2 1U rear panel rack kit for small Redbox range, e.g., RB-BL2
Fig E: RB-RK2 Small Redbox Rear Rack-mount Kit.
e.g. for tting an RB-BL2:
Wherever you see this symbol an RB-RK2 small Redbox rear panel 19” rack kit can be used :
RB-RK3 1U rear panel rack kit for large Redbox range, e.g., RB-DA6
Fig F: RB-RK3 Large Redbox Rear Rack-mount Kit.
e.g. for tting an RB-DA6:
Wherever you see this symbol an RB-RK3 large Redbox rear panel 19” rack kit can be used :
Note: When tting the rear-mounting rack-kits, a notch has been
left on the inside of the right-hand rack-piece for the mains cable to
pass through. Make sure that the mains cable has been put through
the notch before attaching the right hand rack-piece.
SAFETY & INSTALL ATION
INFORMATION
SAFETY & INSTALLATION INFORMATION