Manual
Table Of Contents
- Contents
- Figures
- Warranty
- Safety Information
- 1 RB-UL1 Single, RB-UL2 Dual & RB-UL4 Quad Stereo Unbalanced To Balanced Converters
- 2 RB-LU4 Quad Stereo Balanced To Unbalanced Converter
- 3 RB-BL2 Single & RB-BL4 Dual Bi-Directional Matching Converter
- 4 RB-PA2 Dual Stereo RIAA Phono Amplifier
- 5 RB-LI2 Stereo Line Isolation Unit
- 6 RB-PLI6 6 Way Mono Passive Line Isolation Unit
- 7 RB-DA6 & RB-DA6G 6 Way Stereo Distribution Amplifier
- 8 RB-DA4x5 4 Input 4 x 5 Output Distribution Amplifier/Mixer
- 9 RB-DDA6A 6 Way Stereo AES/EBU Digital Distribution Amplifier and RB-DDA6S 6 Way Stereo S/PDIF Dig
- 10 RB-DDA6W 6 Way Word Clock Distribution Amplifier
- 11 RB-HD1 Stereo Headphone Amplifier & RB-HD2 Dual Headphone Amplifier
- 12 RB-HD6 6 Way Headphone Distribution Amplifier
- 13 RB-DHD6 Digital 6 Way Headphone Distribution Amplifier
- 14 Connectors & Cabling
- Glossary
iv
Redbox User Handbook No 2
Power Cable and Connection
An IEC power connector is supplied with the Redbox, which has a moulded plug, attached
– this is a legal requirement. If no moulded plug has been supplied with your Redbox, please
contact your supplier, because an IEC connector is always supplied from the Sonifex factory.
If for any reason, you need to use the Redbox with a dierent power cable, you should use
the following wiring guidelines:
Wire Colour Connection
Green, or green and yellow Earth (E)
Blue, or Black Neutral (N)
Brown, or Red Live (L)
Fig B: Mains Cable Wire Colours
Ordering the Correct Mains Lead
When ordering a Redbox from Sonifex, it is helpful if you can specify your required
operating voltage and mains lead. After the product code add:
UK, for 230V, UK 3 pin to IEC lead
EC, for 230V, European Schuko 2 pin to IEC lead
US, for 115V, 3 pin to IEC lead
AU for 230V, Australasian 3 pin to IEC lead
Fig C: Mains Lead Table.
E.g. order RB-BL2 UK for a UK IEC lead to be supplied.
Installation Information
Atmosphere
The units should be installed in an area that is not subject to excessive temperature
variation (<0°C, >50°C), moisture, dust or vibration.
Electromagnetic Radiation
The cover is connected to earth by means of the xing screws. It is essential to maintain
this earth ground connection to ensure a safe operating environment and provide
electromagnetic shielding.
Fitting Redboxes
Redboxes can be xed to the underside of a mixing desk, or other surfaces using 4.2mm
holes in the sides and xed with 2 x M4 screws or 2 x No. 6 countersink wood screws.
SAFETY & INSTALL ATION
INFORMATION
SAFETY & INSTALLATION INFORMATION