Handbook

Redbox User Handbook No 1
67
SYNCHRONISERS, DELAYS &
SILENCE DETECTORS
SYNCHRONISERS, DELAYS & SILENCE DETECTORS - RB-DS2
7
128MB
32 kHz 44.1 kHz 48 kHz
16 bit 24 bit 16 bit 24 bit 16 bit 24 bit
Samples 32878592 16439296 32878592 16439296 32878592 16439296
Fields 25fps 51372 25686 37277 18638 34248 17124
24fps 49317 24658 35786 17893 32878 16439
30fps 61647 30823 44732 22366 41098 20549
30df 61585 30792 44688 22344 41057 20528
Frames 25fps 25686 12843 18638 9319 17124 8562
24fps 24658 12329 17893 8946 16439 8219
30fps 30823 15411 22366 11183 20549 10274
30df 30792 15396 22344 11172 20528 10264
Time (hh:mm:ss) 00:17:07 00:08:33 00:12:25 00:06:12 00:11:24 00:05:42
128MB
64 kHz 88.2 kHz 96 kHz
16 bit 24 bit 16 bit 24 bit 16 bit 24 bit
Samples 32878592 16439296 32878592 16439296 32878592 16439296
Fields 25fps 25686 12843 18638 9319 17124 8562
24fps 24658 12329 17893 8946 16439 8219
30fps 30823 15411 22366 11183 20549 10274
30df 30792 15396 22344 11172 20528 10264
Frames 25fps 12843 6421 9319 4659 8562 4281
24fps 12329 6164 8946 4473 8219 4109
30fps 15411 7705 11183 5591 10274 5137
30df 15396 7698 11172 5586 10264 5132
Time (hh:mm:ss) 00:08:33 00:04:16 00:06:12 00:03:06 00:05:42 00:02:51
Fig 7-8: Maximum Delays in Extended Mode with 128 MB Compact Flash™ Memory Card Installed
Note: 1. A maximum of 2GB can be installed.
2. In Extended Mode, the Metres selection is disabled.
3. The delays shown are for a stereo signal; in Extended Mode dual mono operation is not
available.
4. The delay times shown can be doubled for a mono signal.
5. To operate correctly, the ashcard must support PIO Mode 4, or higher, such as the SanDisk
Standard CF cards.
Opening the RB-DS2 to Add a Compact Flash Card
Warning: The power must be switched o at the supply and the power lead disconnected
before opening the unit. Removal of the cover can expose dangerous voltages.
1. Remove the 4 screws in the corners of the rear panel.
2. Remove the 4 screws on the top and bottom panels which hold the rear panel in place (2
on the top and 2 on the bottom).
3. Remove the screw on the front panel immediately to the left of the Bypass button.
The rear panel and main PCB will slide backwards out of the metal chassis giving you access
to the Compact Flash slot. To put the unit back together, slide the PCB back into the chassis
and ret the screws in reverse order.