Handbook

112
Redbox User Handbook No 1
MAIN Source Select and Indicators
This button allows you to select which input source you would like to use, from one of the
AES/EBU, S/PDIF or TOSlink inputs. The three LEDs above the button illustrate which source
is selected. The button itself will also be illuminated.
Button Colour Indication
Solid green Indicating that this is the input that is
currently being output
Solid red Indicating that this input is not selected
Flashing between green and red Indicating a loss of lock to that input
There are also green and red LEDs, one of each for both left and right channels to show the
programme and alarm state of the input. The programme LEDs will be illuminated if the
level is above the current silence threshold. If the input is in an alarmed state, the red alarm
LEDs will be illuminated.
AUX Source Select and Indicators
The operation of this button is identical to the above.
RESTORE Button
The Restore button is used for restoring the main source signal when the unit is operating
in Manual Mode. When the main source signal returns after it has timed out, the AUTO
LED ashes, indicating that the source signal can be restored. When the Restore button is
pressed the main source returns. This can be remotely controlled using pin 7 of the remotes
connector.
SYNC Mode button
This button allows you to cycle through the synchronisation modes. The LEDS around the
button display which mode has been selected. If the selected synchronisation source
(see front panel DIPSwitch section for settings) is not locked, the button will ash green and
red.
SERIAL Mode indicator
If serial mode is selected (see front panel DIPSwitch section for settings) this led will be
illuminated.
Reset Button
In the unlikely event that the RB-DSD1 unit fails to respond, press the reset button to reboot
the unit (see Fig 10-3 for location).
10
SYNCHRONISERS, DELAYS &
SILENCE DETECTORS
SYNCHRONISERS, DELAYS & SILENCE DETECTORS - RB-DSD1