Handbook

SignalLED User Handbook

SIGNALLED STUDIO ILLUMINATED SIGNS

SignalLED User Handbook

SIGNALLED STUDIO ILLUMINATED SIGNS

Setting The Colour & Display Mode(s) of The Sign

&BDITJEFPGUIFTJHODBOCFTFQBSBUFMZDPOUSPMMFEBOEDBOTIPXBEJòFSFOUDPMPVSCZ

signalling inputs if you require, or the whole sign can be controlled from one signalling

JOQVU5IFTJHODBOBMTPCFDPOöHVSFEGPSEJòFSFOUTUBUFTTPUIBUXJUIOPTJHOBMMJOHJOQVU

QSFTFOUUIFTJHODBOJMMVNJOBUFBOEUIFOCFJOBEJòFSFOUTUBUFXIFOPSCPUITJHOBMMJOH

inputs are applied. Thus the appearance of the sign can be made extremely versatile if

you wish.

Mounting The Wall Plate

To create an attractive invisible-xing nish the SignalLED assembly is clipped into a wall

mount plate. The wall mount plate must be securely tted to a smooth, solid surface before

attempting to t the SignalLED assembly.

It is recommended to route the signal and power supply cables before nalising the

mounting of the sign. These cables can be routed either through the central aperture in the

wall mount plate, or through the cable cutouts in the back of the wall mount moulding. Use

a sharp knife to remove the thinner areas of the moulding in the positions shown in Fig 3 if

you need to route the cables this way.

- Drill 2 holes, 34mm deep, using a 6mm diameter masonry drill at the pitch shown on

the drawing Fig 2.

- Insert the wall plugs ush with the surface.

- Position the wall mount plate vertically and x to the wall using the large ange

screws. Do not substitute other xings because they may not fully support the sign

and may invalidate the warranty.

- Use a spirit level on the wall mount plate to set the sign level and vertical before fully

tightening.

The screws can also be used for xing into wood. For correct tting drill a small pilot hole

into the wood before tting the screw.

Connecting The Power & Signal Connections

It is recommended that the LD-IT SignalLED end mount sign installation tool is used to assist

the termination of the power and signal connections. The tool is designed to hold the sign

on the pre-tted wall mount plate leaving both hands free to make the connections, as

shown in Fig. 4.

Fig 4: LD-IT End mount sign installation tool

9) This combination is then xed to the left hand ush mount assembly end moulding

with the 4 supplied No.4 x ¾ self tap screws. Do not substitute any other screws in

these positions and do not reuse the screws removed from these positions because

they will not support the sign correctly.

10) Please refer to the installation notes for the LD-40E style signs to complete the nal

tting and colour/conguration set-up.

Fig 14: Left Hand Conversion Re-assembly