Manual

Redbox RB-DDA22 User Handbook

Safety Information

Safety of Mains Operated Equipment

This equipment has been designed to meet the safety regulations currently

advised in the country of purchase and it conforms to the safety regulations

specied by use of the CE Mark.

Warning : There are no user serviceable parts inside the equipment. If you should ever

need to look inside the unit, always disconnect the mains supply before removing the

equipment covers.

Voltage Setting Checks

Ensure that the machine operating voltage is correct for your mains power supply by

checking the box in which your Redbox was supplied. The voltage is shown on the box

label. The available voltage settings are 115V, or 230V. Please note that all Redboxes are

either switchable between 115V and 230V, or have a universal power supply.

Fuse Rating

The RB-DDA22 is supplied with a single fuse in the live conducting path of the mains

power input. For reasons of safety it is important that the correct rating and type of fuse is

used. Incorrectly rated fuses could present a possible re hazard, under equipment fault

conditions. The fuse rating for the RB-DDA22 is:

230 or 115 V operation - 2A 5 x 20mm SB

The active fuse is tted on the outside rear panel of the unit.

Power Cable and Connection

An IEC power connector is supplied with the RB-DDA22 which has a moulded plug

attached – this is a legal requirement. If no moulded plug has been supplied with your

RB-DDA22, please contact your supplier, because an IEC connector is always supplied from

the Sonifex factory.

If for any reason, you need to use the RB-DDA22 with a dierent power cable, you should

use the following wiring guidelines.

Wire Colour Connection

Green, or green and yellow Earth (E)

Blue, or Black Neutral (N)

Brown, or Red Live (L)

Fig B: Power Connections

Connect the equipment in accordance with the connection details and before applying

power to the unit, check that the machine has the correct operating voltage for your mains

power supply.

Important Note : The terminal marked on the rear panel must be earthed.

SAFETY INFORMATION