Manual
SignalLED User Handbook
5
2
INSTALLATION
INSTALLATION
End Mounting Requirements
To create an attractive invisible-xing nish,
the SignalLED assembly is clipped into a wall
mount plate. The wall mount plate must be
securely tted to a smooth, solid surface before
attempting to t the SignalLED assembly. Drill 2
holes, approximately 34mm deep, using a 6mm
diameter masonry drill, and attach the wall
mount plate (coloured red in the illustration
above) to the wall. At this point, the LD-IT, end-
mount installation tool can be used to hold the
sign in place while you connect the power and
Metal Plate
5mm screw goes here
30mm
25mm
33mm
65mm
140mm
38mm minimum
44mm
Ceiling
= Wall Mounting Plate shown in red
= Wall Mounting Holes
= Hanger Slots
signal cables. The cable retention clips can be used to hold the cables in the sign. See page
4 for information on connecting the Power and Signal cables.
The sign is tted by locating the four internal hanger plate hooks into the four slots
in the wall mount plate. Once located, hold the sign around the end moulding of the
SignalLED assembly (where the door is tted) and press down into its nal position.
The sign retaining pins will clip into the indentations on the side of the wall mount
plate and this should result in a click as the plastic pins move into their nal position.
Note: a reasonable amount of force is needed to fully connect the LED sign assembly to
the wall plate.
LD-KC1 Ceiling Mounting Kit
Open the end covers of the sign. Take the 5mm screw out of each of the
LD-KC1 brackets and use the screws to attach the sign covers to them,
where indicated on the drawing below. Ensure that the sign cover
sits comfortably against the metal plates on each of the bracket.
The LD-KC1 ceiling mounting kit can be used for mounting a 40cm or
DNøVTINPVOUJOHTJHOFJUIFSEPXOGSPNUIFDFJMJOH
or up from a surface, e.g. table-top
or top of a rack.
81mm
minimum
clearance to
open the
DIPSwitch
DPWFSøBQ
Fig 2-2: End Mounting Requirements
Fig 2-3: LD-KC1 Ceiling Mounting Kit