Manual

16
SignalLED User Handbook
5
APPENDICES
APPENDICES
Fig 5-4: Removing the Right Hand Flush Wall Moulding Fig 5-5: Right Hand Conversion Re-Assembly
Left Hand Side Fitting of the Conversion Kit
Note: With this conversion you will be removing the PCB from the sign so full anti-static
precautions must be taken to protect the PCB from damage. Failure to do so may result in
the sign not working and invalidating the warranty.
 0QFOUIFFOEDPWFSPOUIFSJHIUIBOEøVTINPVOUBTTFNCMZCZSFNPWJOHUIFTFMG
tapping screw with a No.1 pozi-drive screwdriver.
 3FNPWFUIFTNBMMTDSFXTUIBUIPMEUIF1$#JOUPUIFSJHIUIBOEøVTINPVOUBTTFNCMZ
and withdraw the PCB. Place the PCB on an antistatic surface.
 3FNPWFUIFSJHIUIBOEøVTINPVOUBTTFNCMZCZVOTDSFXJOHUIFTDSFXTUIBUöYUIF
end moulding to the aluminium tube. These are located inside at the bottom of the
end moulding.
4) Align the 4 pins of the extrusion end cover with the screw holes in the exposed end of
the aluminium tube. Note the orientation of the cut-out with the clear sign board and
press t the end cover fully onto the aluminium tube.
 0QFOUIFFOEDPWFSPOUIFMFGUIBOEøVTINPVOUBTTFNCMZCZSFNPWJOHUIFTFMG
tapping screw with a No.1 pozi-drive screwdriver.
 3FNPWFUIFøVTIXBMMNPVOUNPVMEJOHGSPNUIFFOENPVMEJOHCZVOTDSFXJOHUIF
4 screws visible under the cover.
7) Replace the PCB into the left hand end moulding aligning the PCB edge with the guide
tracks in the aluminium extrusion. Ret the 2 small screws that hold the PCB, taking
care not to over tighten and strip the plastic.
8) Fit the internal hanger plate into the end wall mount moulding. Align the semi-circular
cut-out in the hanger plate with the raised section above the serial number label,
which indicates the bottom of the assembly. Also make sure that the hanger plate ts
into the slots in the wall mount moulding.