Manual

SignalLED User Handbook

APPENDICES

3) Align the 4 pins of the extrusion end cover with the screw holes in the exposed end of

the aluminium tube. Note the orientation of the cut-out with the clear sign board and

press t the end cover fully onto the aluminium tube.

 0QFOUIFFOEDPWFSPOUIFSJHIUIBOEøVTINPVOUBTTFNCMZCZSFNPWJOHUIFTFMG

tapping screw with a No.1 pozi-drive screwdriver.

 3FNPWFUIFøVTIXBMMNPVOUNPVMEJOHGSPNUIFFOENPVMEJOHCZVOTDSFXJOHUIF

screws visible under the cover See Fig 5-4.

6) Fit the internal hanger plate into the end wall mount moulding. Align the semi-circular

cut-out in the hanger plate with the raised section above the serial number label,

which indicates the bottom of the assembly. Also make sure that the hanger plate ts

into the slots in the wall mount moulding.

 5IJTDPNCJOBUJPOJTUIFOöYFEUPUIFSJHIUIBOEøVTINPVOUBTTFNCMZFOENPVMEJOH

with the 4 supplied No.4 x ¾ self tap screws. See Fig 5-5. Do not substitute any other

screws in these positions and do not reuse the screws removed from these positions,

because they will not support the sign correctly.

8) Please refer to the installation notes for the LD-40E style signs to complete the nal

tting and colour/conguration set-up.

Fig 5-2: Kit Components Used for the Conversion Fig 5-3: Removing the Left Hand Assembly