Manual

SignalLED User Handbook

APPENDICES

Appendix 1

LD-KE1 SignalLED Conversion Kit, Single Flush Mount to End Mount

5PDPOWFSUUIF-%'-%'TUZMFøVTINPVOUTJOHMFTJEFETJHOTJOUPTJOHMFTJEFEFOE

mount signs you will need to t the LD-KE1 conversion kit. Please follow these instructions

carefully.

Note: You’ll need the following tools to use the conversion kit:, a No. 0 and No.1 Pozi-drive

screwdriver.

Take care not to damage the clear surface of the sign board. The surface will be marked by

swarf or rough surfaces, so please use a clean cloth to hold the sign.

Because the sign is single sided the text will only be correctly viewable from one side. If the

text must be viewed from one particular side this must be chosen initially as it will aect the

disassembly and subsequent re-assembly of the sign

As standard the SignalLED PCB is tted into the right hand end of the LD-20F & LD-40F

(see Fig 5-1). If you would like the sign to be viewable with the right hand side of the sign

mounted onto the wall please use the ‘Right Hand Side’ tting instructions.

If you would like the sign to be viewable with the left hand side of the sign mounted onto

the wall, please use the ‘Left Hand Side’ tting instructions.

Fig 5-1: Sign Components to be Converted

Right Hand Side Fitting of the Conversion Kit

 0QFOUIFFOEDPWFSPOUIFMFGUIBOEøVTINPVOUBTTFNCMZCZSFNPWJOHUIFTFMG

tapping screw with a No.1 pozi-drive screwdriver.

 3FNPWFUIFMFGUIBOEøVTINPVOUBTTFNCMZCZVOTDSFXJOHUIFTDSFXTUIBUöYUIF

end moulding to the aluminium tube. These are located inside at the bottom of the

end moulding. See Fig 5-3.