Manual

12
SignalLED User Handbook
3
PROGRAMMING
PROGRAMMING
Setting The Illumination Mode
5PTFUUIF*MMVNJOBUJPO.PEFQSFTTUIF.0%&CVUUPOBOEVTFUIFBOEoCVUUPOT
to step through the modes according to the table below:
Illumination
Mode Number
Operation
0 Whole sign on
1 Flash whole sign ( ½ second on, ½ second o)
2 Pulse whole sign (4 pulses in ½ second on, ½ second o)
3 Fade whole sign ( fade up in 2 seconds, fade down in 2 seconds)
4 Flash alternate Sections
5 Pulse alternate Sections
6 Fade alternate Sections
Fig 3-5: Illumination Mode Table
Press the INPUT (8) button to congure another input state or press & hold the PROGRAM
(7) button to exit the Programming Mode, until the LEDs cascade away & to the receiver
again.
If The Sign Appears To Be O
When starting to program the sign it may be unclear what the initial state of the sign is. For
instance if the sign is o, it’s hard to know whether the Section 1 colour is set to o, whether
the Section 2 colour is set to o, whether an entire ‘dead zone’ has been congured, or
whether there is a mix of all 3 of these states. To make sure that the display state is known,
perform the following actions:
Go into Programming Mode by pressing and holding the PROGRAM (7) button.1.
Press the INPUT (8) button to select the required input.2.
Press the DIVIDE (6) button to enter divide programming. Press the + (2) button three 3.
times to ensure that Section 1 is visible.
1SFTTUIF%*7*%&CVUUPOBHBJOBOEQSFTTUIFoCVUUPOUPFOTVSFUIBUTFDUJPOJT4.
visible
1SFTTUIF%*7*%&CVUUPOBHBJOBOEQSFTTUIFoCVUUPOUPFOTVSFUIBUUIFEFBE5.
zone is visible.
If the display is still o then:
1. Press the COLOUR (5) button again and press the + (2) button to ensure that Section 1
is assigned a colour.
2. Press the COLOUR (5) button again and press the + (2) button enough times to ensure
that Section 2 is assigned a dierent colour to that assigned to Section 1.
This should conrm that a colour can be programmed.