Manual

SignalLED User Handbook

PROGRAMMING

Pressing the + (2) button advances the Section 1 divide position one LED for each time you

press the button. If Section 1 reaches Section 2 then Section 2 is pushed back (i.e. its divide

position retreats).

1SFTTJOHUIFoCVUUPODBVTFTUIF4FDUJPOEJWJEFQPJOUUPSFUSFBU#VUUIJTUJNF4FDUJPO

2’s divide position remains unchanged and a dead zone (i.e. no LEDS illuminate here) is

DSFBUFE4JNJMBSMZXIFO4FDUJPOJTCFJOHTFUUIFoCVUUPOXJMMBEWBODF4FDUJPOJOUP

Section 1 causing the Section 1 divide position to retreat, but pressing the + (2) button will

cause the divide position of Section 1 to remain unchanged again introducing a dead zone.

This is complex to explain and it’s probably better that you try it yourself to see how

it works!

The divide point for Section 1 or Section 2 cannot be moved so that the Section 1 is not

visible. To set the sign to all one colour we suggest moving the divide point of Section 1 to

its maximum which will make Section 2 invisible, although the same result can be achieved

by setting both sections to the same colour.

Setting The Colour of The Section/Sign

To set the colour of each Section, (or the whole sign if only one Section is dened), press

the COLOUR (5) button to select Section 1. Pressing the colour button again alternates the

currently selected section.

1SFTTUIFBOEoCVUUPOTUPDIBOHFUIFTFMFDUFEDPMPVSBDDPSEJOHUPUIFDPMPVSUBCMF

below. Normally the User colour setting is undened and therefore not selectable. However,

for special orders Sonifex can create distinct colour sets and these will use the User colour

setting.

Colour Number Set Colour

1O

2 White

3 Orange

4 Brick Red

5Cyan

6Red

7 Magenta

8 Blue

9 Yellow

10 Green

11 User

Fig 3-4: Colour Table

To set the sign to be o for a particular input, set the Colour above to ‘O’.

Setting The Sign Brightness

To set the brightness of the whole sign, press the BRIGHT (4) button and then the + (2) or

oCVUUPOTUPJODSFBTFPSEFDSFBTFUIFCSJHIUOFTTPGUIFTJHO'PSGBEFNPEFT*MMVNJOBUJPO

Modes 3 and 6, see below) this will set the peak brightness of the sign.