Manual

6
SignalLED User Handbook
INSTALLATION
INSTALLATION
2
Connecting The Power and Signal Connections For Flush Mounted Signs
To get access to the cable connection block and the mode switches which are on the PCB
inside the sign, the door on the underside of the end plastic moulding must be opened.
To open the door push the clip towards the sign and pull down on the small lip, see Fig 2-5.
Do not attempt to remove the door from the end moulding. Access to the connection block
and the mode switches is possible with the door fully open.
Fig 2-4: Cable Routing Cut-Outs Fig 2-5: Opening The Access Door
Fig 2-6: Mode Settings & Connection Block
   
    
   



 
   
    
Connection
Block
1
4
3
2
IR Receiver
Input LED
Indicators