User Guide

Last updated by ah – October 30, 2000
SonicWALL Configuration
On the SonicWALL, create an SA.
1. Change the IPSec Keying Mode to IKE.
2. Fill in the IPSec gateway (in this example 216.5.31.42)
3. Fill in the appropriate Destination Network (in this example 10.0.0.0) and Subnet Mask (in
this example 255.255.255.0)
4. Select ESP DES HMAC MD5 or ESP 3DES HMAC MD5
A Sample Screen shot from SonicWALL firmware version 5.0 is displayed below
CISCO IOS/PIX Configuration
The Cisco IOS/PIX system has a very rich and complex instruction set. Before you proceed to
enter commands on the Cisco Product, you must be logged into the enable/configure terminal
mode. For more details on logging into your Cisco Product and configuring settings, please refer
to the Cisco documentation available online at http://www.cisco.com
Once you are logged into the enable/configure terminal, use the commands below to setup a SA
complimentary to the SA setup on the SonicWALL as shown above in the screen shot.
The commands below are not a complete guide to configuring a Cisco IOS/PIX product, but are
intended only to guide existing Cisco users. Refer to the Cisco documentation (www.cisco.com
)
for more information regarding the commands below.