User Guide

Network Access Rules Page 85
3. You do not have to remove the Deny Default * to LAN Rule in the Rules window
to allow inbound access to a Public LAN Server.
4. Click Update. Once the SonicWALL has been updated, a message confirming the
update is displayed at the bottom of the browser window.
Repeat these instructions to configure additional Public LAN Servers.
Additional Notes:
•In Standard Network Addressing Mode, users on the Internet access Public LAN
Servers at their valid, LAN IP addresses.
• If NAT is enabled, users on the Internet access Public LAN Servers at the SonicWALL
WAN IP (NAT Public) Address.
• If users on the Internet cannot access Public LAN Servers, make sure that the Public
LAN Servers have been configured properly and have Internet connectivity. Also,
confirm that the DNS MX record points to the correct IP address--the WAN IP (NAT
Public) Address, if NAT is enabled.
• If you have multiple LAN servers of the same service, such as multiple Web servers,
and your SonicWALL has been configured for Standard Network Addressing
Mode, you must to create additional rules in the Rules window for the remaining
Public LAN Servers.
• If you have multiple LAN servers of the same service, such as multiple Web servers,
and you have enabled NAT, you must configure One-to-One NAT. Go to Chapter 9 for
more information about One-to-One NAT.
integrated_manual.book Page 85 Friday, October 12, 2001 2:56 PM