Manualshelf

User Guide

ManualsBrandsSonicWALL ManualsOtherINTERNET SECURITY APPLIANCE
181182183184185186187188189190
Page 184 SonicWALL Internet Security Appliance User’s Guide
Appendix D - Configuring TCP/IP Settings
The following steps describe how to configure the Management Station TCP/IP settings in
order to initially contact the SonicWALL. It is assumed that the Management Station can
access the Internet through an existing connection.
The SonicWALL is pre-configured with the IP address “192.168.168.168". During the initial
configuration, it is necessary to temporarily change the IP address of the Management
Station to one in the same subnet as the SonicWALL. For initial configuration, set the IP
address of the Management Station to "192.168.168.200".
Make a note of the Management Station's current TCP/IP settings. If the Management
Station accesses the Internet through an existing broadband connection, then the TCP/IP
settings can be helpful when configuring the IP settings of the SonicWALL.
From a Windows 95 or 98 computer, do the following:
1. From the Start list, highlight Settings and then select Control Panel.
2. Double-click the Network icon in the Control Panel window.
3. Double-click TCP/IP in the TCP/IP Properties window.
4. Select the Specify an IP Address radio button.
5. Enter "192.168.168.200" in the IP Address field.
6. Enter "255.255.255.0" in the Subnet Mask field.
7. Click OK, and then click OK again.
8. Restart the computer for changes to take effect.
From a Windows2000 computer, do the following:
1. From the Start list, highlight Settings and then select Control Panel.
2. Double-click the Network icon in the Control Panel window.
3. Double-click TCP/IP in the TCP/IP Properties window.
4. Select the Specify an IP Address radio button.
5. Enter "192.168.168.200" in the IP Address field.
6. Enter "255.255.255.0" in the Subnet Mask field.
7. Click OK, and then click OK again.
From a Macintosh computer, do the following:
1. From the Apple list, choose Control Panel, and then choose TCP/IP to open the
TCP/IP Control Panel.
2. From the Configure list, choose Manually.
integrated_manual.book Page 184 Friday, October 12, 2001 2:56 PM