User Guide

Page 170 SonicWALL Internet Security Appliance User’s Guide
There are two Ethernet ports; one of the following for the LAN and WAN ports:
• Link
Lights up when the Twisted Pair port is connected to a 10Mbps or 100Mbps hub or
switch or directly connected to a computer. Note that the connected Ethernet device
must support the standard Link Integrity test.
• 100
Lights up when the Twisted Pair port is connected to a 100Mbps hub or switch or
directly connected to a computer with a 100Mbps network interface.
• Activity
Flashes when the SonicWALL transmits or receives a packet through the Twisted Pair
port.
SonicWALL SOHO3 and TELE3 Back Panel
The SonicWALL SOHO3 back panel is shown below, followed by a description of each item.
The SonicWALL TELE3 back panel is identical to the SonicWALL SOHO3.
The SonicWALL SOHO3 and TELE3 Back Panel Description
• Reset Switch
Erases the firmware and resets the SonicWALL to its factory clean state. This can be
necessary if you forget the administrator password or the firmware has become
corrupt. This process is described in Appendix E.
• (2) Twisted Pair (10Base-T, 100Base-T) Ethernet Ports
(2) Auto switching 10Mbps/100Mbps Ethernet ports provide connectivity for both
Ethernet and Fast Ethernet networks. The Ethernet ports connect the SonicWALL to
the LAN and WAN using Twisted Pair cable with RJ45 connectors.
Cooling Vents
Reset Switch
10Mbps/100Mbps
LAN Ethernet Port
10Mbps/100Mbps
WAN Ethernet Port
5VDC,2A
Power Input
integrated_manual.book Page 170 Friday, October 12, 2001 2:56 PM