User Guide

Page 168 SonicWALL Internet Security Appliance User’s Guide
There are three Ethernet ports; one for each of the LAN, DMZ, and WAN ports:
• Link
Lights up when the Twisted Pair port is connected to a 10Mbps or 100Mbps hub or
switch, or directly connected to a computer. Note that the connected Ethernet device
must support the standard Link Integrity test.
• 100
Lights up when the Twisted Pair port is connected to a 100Mbps hub or switch or
directly connected to a computer with a 100Mbps network interface.
• Activity
Flashes when the SonicWALL PRO 100 transmits or receives a packet through the
Twisted Pair port.
SonicWALL PRO 100 Back Panel
The SonicWALL PRO 100 back panel is shown below, followed by a description of each item.
The SonicWALL PRO 100 Back Panel Description
• Reset Switch
Erases the firmware and resets SonicWALL PRO 100 to its factory clean state. This can
be necessary if the administrator password is forgotten, or the firmware has become
corrupt. Instructions for erasing the SonicWALL firmware are described in Appendix E.
• (3) Twisted Pair (10Base-T, 100Base-T) Ethernet Ports
(3) Auto switching 10Mbps/100Mbps Ethernet ports provide connectivity for both
Ethernet and Fast Ethernet networks. The Ethernet ports connect the SonicWALL PRO
100 to the LAN, DMZ, and WAN using Twisted Pair cable with RJ45 connectors.
• Power Input
10Mbps/100Mbps
DMZ Ethernet Port
Reset Switch
10Mbps/100Mbps
LAN Ethernet Port
10Mbps/100Mpbs
WAN Ethernet Port
5VDC,2A
Power input
Cooling Vents
integrated_manual.book Page 168 Friday, October 12, 2001 2:56 PM