User Guide

Page 166 SonicWALL Internet Security Appliance User’s Guide
• Alarm
Lights up and flashes for 10 seconds when an event generates an alert. Alarm LED
flashes for 10 seconds. Alert events are defined in the Log Settings section in Chapter
5.
There are three Ethernet ports; one for each of the LAN, DMZ, and WAN ports:
• Link
Lights up when a Twisted Pair connection is made to another Ethernet device (usually
a hub) on the port. Note that the device connected to the SonicWALL must support the
standard Link Integrity test.
• Activity
Lights up when the SonicWALL transmits or receives a packet through the Twisted Pair
port onto the network.
SonicWALL PRO 200 and PRO 300 Back Panel
The SonicWALL PRO 200 back panel is shown below, followed by a description of each item.
The SonicWALL PRO 300 back panel is identical to the SonicWALL PRO 200.
SonicWALL PRO 200 and SonicWALL PRO 300 Back Panel Description
• (3) Twisted Pair (10Base-T, 100Base-T) Ethernet Ports
(3) Auto switching 10Mbps/100Mbps Ethernet ports provide connectivity for both
Ethernet and Fast Ethernet networks. The Ethernet ports connect the SonicWALL to
the LAN, DMZ, and WAN using Twisted Pair cable with RJ45 connectors.
• Serial
DB-9 RS-232 Serial port.
• Reset Switch
Resets the SonicWALL PRO 200 or the SonicWALL PRO 300 to its factory clean state.
This can be required if you forget the administrator password, or the SonicWALL
Cooling
Vents
10Mbps/100Mbps
LAN Ethernet Port
10Mbps/100Mbps
DMZ Ethernet Port
10Mbps/100Mbps
WAN Ethernet Port
RS-232
Serial Port
Reset
Switch
5VDC, 2A
Power Input
integrated_manual.book Page 166 Friday, October 12, 2001 2:56 PM