User Guide

SonicWALL VPN Page 141
7. Create an Outgoing SPI using alphanumeric characters.
8. Select Strong Encrypt (ESP 3DES) as the Encryption Method.
9. Enter the Encryption Key from the Main Office configuration.
10. Click Add New Network. Type the IP address, “192.168.11.1” in the Range Start
field. Type the IP address, “192.168.11.255” in the Range End field. This Range End
value is appropriate even if NetBIOS broadcast support is enabled. Leave the subnet
mask field blank. Click Update.
11. Click Advanced Settings and select the features that apply to the SA.
• Enable Windows Networking (NetBIOS) broadcast - if the remote clients use
Windows Network Neighborhood to browse remote networks.
• Apply NAT and firewall rules - to apply NAT and firewall rules to the SA or just
firewall rules if in Standard mode.
• Forward packets to remote VPNs - if creating a “hub and spoke” network
configuration
• Route all internet traffic through this SA - if forcing internet traffic from the
WAN to use this SA to access a remote site.
• Default LAN Gateway if specifying the IP address of the default LAN route for
incoming IPSec packets for this SA. This is used in conjunction with the Route all
internet traffic through this SA check box.
12. Click OK, and then click Update.
integrated_manual.book Page 141 Friday, October 12, 2001 2:56 PM