User Guide

Page 100 SonicWALL Internet Security Appliance User’s Guide
• Specified address ranges are attached to the WAN link
Select this option if it is easier to specify the devices on your WAN. Then enter your
WAN IP address range(s). Computers connected to the WAN port that are not included
are inaccessible to users on your LAN.
• Add Range
To add a range of addresses, such as "199.2.23.50" to "199.2.23.54", enter the
starting address in the From Address field and the ending address in the To Address
field. An individual IP address should be entered in the From Address field only.
Note: Up to 64 address ranges can be entered.
Click Update. Once the SonicWALL has been updated, a message confirming the update is
displayed at the bottom of the browser window.
Routes
If you have routers on your Local Area Network, you have to configure the Static Routes
section of the SonicWALL.
Click Advanced on the left side of the browser window, and then click the Routes tab.
The SonicWALL LAN IP Address, LAN Subnet Mask, WAN IP Address and WAN/DMZ Subnet
Mask are displayed in the Current Network Settings section. Refer to these settings
when configuring your Static Routes.
integrated_manual.book Page 100 Friday, October 12, 2001 2:56 PM