User Guide
Table Of Contents
- SonicWALL TZ 190 Wireless Getting Started Guide
- Before You Begin
- Checking Package Contents
- Any Items Missing?
- Recording Configuration Information
- Recording Internet Service Provider (ISP) Information
- Overview of the SonicWALL TZ 190 Wireless Appliance
- WWAN PC Card Setup
- Sprint Wireless PC Card Setup
- Cingular Wireless PC Card Setup
- Verizon Wireless PC Card Setup
- Before You Register
- Creating a mysonicwall.com Account
- Registering Your SonicWALL TZ 190 Wireless Appliance
- Insert the WWAN PC Card Modem
- Apply Power to the SonicWALL TZ 190 Wireless
- Connect Directly to the SonicWALL TZ 190 Wireless Appliance
- Log into the SonicWALL TZ 190 Wireless Appliance
- If the SonicWALL Configuration Wizard Does Not Appear
- SonicWALL TZ 190 Wireless Setup Wizard
- Configuring WWAN as Failover
- Configuring LAN Settings
- Log Into the Management Interface
- WWAN Connection Status
- Manage WWAN Connection
- Check Internet Connectivity
- Windows XP
- Windows 2000
- Windows NT
- Safety Instructions and Regulatory Information
DRAFT not for production
Page 40
Safety Instructions and Regulatory Information
Regulatory Model/Type Product Name
APL18-046 TZ 190 Wireless
Mounting the SonicWALL
Mount in a location away from direct
sunlight and sources of heat. A maximum
ambient temperature of 104º F (40º C) is
recommended.
Route cables away from power lines,
fluorescent lighting fixtures, and sources
of noise such as radios, transmitters, and
broadband amplifiers
The included power cord is intended for
use in North America only. For European
Union (EU) customers, a power cord is
not included.
Ensure that no water or excessive
moisture can enter the unit.
Allow unrestricted airflow around the unit
and through the vents on the side of the
unit. A minimum of 1 inch (25.44mm)
clearance is recommended.
Consideration must be given to the
connection of the equipment to the supply
circuit and the effect of overloading the
circuits has minimal impact on overcurrent
protection and supply wiring. Appropriate
consideration of equipment nameplate
ratings must be used when addressing
this concern.
Lithium Battery Warning
The Lithium Battery used in the
SonicWALL security appliance may not
be replaced by the user. Return the
SonicWALL security appliance to a
SonicWALL-authorized service center for
replacement with the same or equivalent
type recommended by the manufacturer.
If, for any reason, the battery or
SonicWALL security appliance must be
disposed of, do so following the battery
manufacturer's instructions.
Cable Connections
All Ethernet and RS232 (Console) cables
are designed for intra-building connection
to other equipment. Do not connect these
ports directly to communication wiring or
other wiring that exits the building where
the SonicWALL is located.
Power Supply Information
If the power supply is missing from your
SonicWALL product package, please
contact SonicWALL Technical Support at
408-752-7819 for a replacement. This
product should only be used with a UL
listed power supply marked “Class 2” or
“LPS”, with an output rated 12 VDC,
minimum 1.66 A.