User Guide
Table Of Contents
- SonicWALL TZ 190 Wireless Getting Started Guide
- Before You Begin
- Checking Package Contents
- Any Items Missing?
- Recording Configuration Information
- Recording Internet Service Provider (ISP) Information
- Overview of the SonicWALL TZ 190 Wireless Appliance
- WWAN PC Card Setup
- Sprint Wireless PC Card Setup
- Cingular Wireless PC Card Setup
- Verizon Wireless PC Card Setup
- Before You Register
- Creating a mysonicwall.com Account
- Registering Your SonicWALL TZ 190 Wireless Appliance
- Insert the WWAN PC Card Modem
- Apply Power to the SonicWALL TZ 190 Wireless
- Connect Directly to the SonicWALL TZ 190 Wireless Appliance
- Log into the SonicWALL TZ 190 Wireless Appliance
- If the SonicWALL Configuration Wizard Does Not Appear
- SonicWALL TZ 190 Wireless Setup Wizard
- Configuring WWAN as Failover
- Configuring LAN Settings
- Log Into the Management Interface
- WWAN Connection Status
- Manage WWAN Connection
- Check Internet Connectivity
- Windows XP
- Windows 2000
- Windows NT
- Safety Instructions and Regulatory Information
DRAFT not for production
SonicWALL TZ 190 Wireless Getting Started Guide Page 39
Configuring a Static IP Address
Complete the following section based on your operating system in order to configure
your management computer with a static IP address:
Windows XP
1. From the Start menu, highlight Connect To and then select Show All Connections.
2. Open the Local Area Connection Properties window.
3. Double-click Internet Protocol (TCP/IP) to open the Internet Protocol (TCP/IP)
Properties window.
4. Select Use the following IP address and type 192.168.168.50 in the IP address
field.
5. Type 255.255.255.0 in the Subnet Mask field.
6. Click OK for the settings to take effect.
Windows 2000
1. From your Windows Start menu, select Settings.
2. Open Network and Dial-up Connections.
3. Click Properties.
4. Highlight Internet Protocol (TCP/IP) and click Properties.
5. Select Use the following IP address and type 192.168.168.50 in the IP address
field.
6. Type 255.255.255.0 in the Subnet Mask field.
7. Click OK for the settings to take effect.
Windows NT
1. From the Start menu, highlight Settings and then select Control Panel.
2. Open Network.
3. Double-click TCP/IP in the TCP/IP Properties window.
4. Select Specify an IP Address and type 192.168.168.50 in the IP address field.
5. Type 255.255.255.0 in the Subnet Mask field.
6. Click OK, and then click OK again.
7. Restart the computer for the changes to take effect.