User Guide

Table Of Contents
DRAFT not for production
Page 24
Connect Directly to the SonicWALL TZ 190 Wireless Appliance
Before you can connect your management station to it, you must configure your
management station to accept DHCP addressing or have it set to an address in the
same subnet as the SonicWALL TZ 190 Wireless appliance.
Note: If it is necessary to change networking settings on the computer you are using as
a management station, record your computer’s current network settings so they
can be restored after configuration is complete.
1. Set the computer you are using to manage the SonicWALL TZ 190 Wireless
appliance (management station) to accept DHCP addressing or to have a static IP
address in the 192.168.168.x range, such as 192.168.168.20 and a subnet mask of
255.255.255.0.
Note: For help with setting up a static IP address on your computer, refer to
“Configuring a Static IP Address” on page 39.
2. Using the supplied network cable and the management station, connect the LAN
port on the management station to the LAN (1) port on the back of your
SonicWALL TZ 190 appliance.
SonicWALL TZ 190
Management
Station