User Guide

DRAFT not for production
SonicWALL TZ 190 Wireless Getting Started Guide Page 23
Setting Up Your SonicWALL TZ 190 Wireless Appliance
This section contains the following sub-sections:
• “Insert the WWAN PC Card Modem” on page 23
• “Apply Power to the SonicWALL TZ 190 Wireless” on page 23
• “Connect Directly to the SonicWALL TZ 190 Wireless Appliance” on page 24
• “Log into the SonicWALL TZ 190 Wireless Appliance” on page 25
• “If the SonicWALL Configuration Wizard Does Not Appear” on page 25
Insert the WWAN PC Card Modem
Before inserting the WWAN PC card into your SonicWALL TZ 190 Wireless appliance,
be sure your WWAN PC card is activated and unlocked. If you are not sure whether your
card is unlocked or not, contact the PC Card vendor to verify.
Note: Do not insert or remove the WWAN PC card while the SonicWALL TZ 190
Wireless is powered on.
1. Ensure the TZ 190 Wireless is not connected to a power source.
2. Insert your WWAN PC card modem “face up” into the PC CARD slot on the left side
of the SonicWALL TZ 190 Wireless appliance. The card should sit firmly in place.
Apply Power to the SonicWALLTZ 190 Wireless
1. Connect one end of the power supply to the back of the SonicWALL TZ 190 Wireless
2. Connect the other end of the power supply an appropriate power outlet.
Note: The Power LED on the front panel lights up green when you power the
SonicWALL TZ 190 Wireless appliance. The Test LED lights up and blinks
while the appliance performs a series of diagnostic tests. When the Test LED is
no longer lit, the SonicWALL TZ 190 Wireless appliance is ready for
configuration. If the Test LED stays lit for more than a few minutes after the
initial power on sequence, cycle power to the SonicWALL TZ 190 Wireless
appliance.
324
link/act
10/100
signal
link/act
wan optWWAN
TZ 190