User Guide
Table Of Contents
- SonicWALL TZ 190 Wireless Getting Started Guide
- Before You Begin
- Checking Package Contents
- Any Items Missing?
- Recording Configuration Information
- Recording Internet Service Provider (ISP) Information
- Overview of the SonicWALL TZ 190 Wireless Appliance
- WWAN PC Card Setup
- Sprint Wireless PC Card Setup
- Cingular Wireless PC Card Setup
- Verizon Wireless PC Card Setup
- Before You Register
- Creating a mysonicwall.com Account
- Registering Your SonicWALL TZ 190 Wireless Appliance
- Insert the WWAN PC Card Modem
- Apply Power to the SonicWALL TZ 190 Wireless
- Connect Directly to the SonicWALL TZ 190 Wireless Appliance
- Log into the SonicWALL TZ 190 Wireless Appliance
- If the SonicWALL Configuration Wizard Does Not Appear
- SonicWALL TZ 190 Wireless Setup Wizard
- Configuring WWAN as Failover
- Configuring LAN Settings
- Log Into the Management Interface
- WWAN Connection Status
- Manage WWAN Connection
- Check Internet Connectivity
- Windows XP
- Windows 2000
- Windows NT
- Safety Instructions and Regulatory Information
DRAFT not for production
Page 18
Verifying Your Connection
After the card has been set up on your PC, you can view your connection type and verify
that the WWAN PC Card is transferring data.
Note: In order for the connection testing to be valid, it is important that you first disable
all other network connections, such as a Wi-Fi or LAN connection, before
continuing. Leave only your PC card connection enabled.
1. If the VZAccess Manager program is running, skip to the next step. Otherwise,
navigate to Start > Programs > Verizon > VZAccess Manager to start the
VZAccess Manager program.
The WWAN PC card will take a few minutes to connect to the network. When the
connection is ready, the signal indicator will light up green with bars to indicate
connection strength.
2. Click the Connect button to enable the network connection.
3. If a disclaimer displays, click the Continue button. When the connection attempt is
successful, the bottom-left corner of the VZAccess Manager will read Connected.
4. In the Windows interface, select Start > Run.
5. Enter “cmd” in the Open field and click the OK button.
6. At the prompt, type the command “ipconfig” and press Enter on the keyboard. Your
network device status will display.
Connect/Disconnect
Button - Click here to
connect or disconnect
from the current
network.
Status - Shows
“connected” when
connected to the
Verizon network.
Network Connection
Shows “Verizon
Wireless” when
connected to the
Verizon network.
Signal - Displays the
signal strength of your
current connection.