Manualshelf

Safety Instructions

ManualsBrandsSonicwall ManualsElectronics802.11b VPN Access point
12345678910
Page 5
Lithium Battery Warning
All Models
The Lithium Battery used in the SonicWALL Internet security appliance may not be replaced by
the user. The SonicWALL must be returned to a SonicWALL authorized service center for
replacement with the same or equivalent type recommended by the manufacturer. If, for any
reason, the battery or SonicWALL Internet security appliance must be disposed of, do so
following the battery manufacturer's instructions.
Power Supply Information
Models APL04-016, APL04-017, APL04-01E, and APL04-022
If the power supply is missing from your SonicWALL product package, please contact
SonicWALL Technical Support at 408-752-7819 for a replacement. This product should only be
used with a UL listed power supply marked “Class 2” or “LPS”, with an output rated 5V DC,
minimum 1.5 A.
Model APL11-027, APL11-031, and APL11-024
If the power supply is missing from your SonicWALL product package, please contact
SonicWALL Technical Support at 408-752-7819 for a replacement. This product should only be
used with a UL listed power supply marked “Class 2” or “LPS”, with an output rated 5V DC,
minimum 2.4 A.
Mounting the SonicWALL PRO 200 , PRO 230, PRO 300, and PRO 330
The SonicWALL PRO 200 and SonicWALL PRO 300 are designed to be mounted in a standard
19-inch rack mount cabinet. The following conditions are required for proper installation:
• Use the mounting hardware recommended by the rack manufacturer and ensure that
the rack is adequate for the application.
• Four mounting screws, compatible with the rack design, must be used and hand tight-
ened to ensure secure installation. Choose a mounting location where all four mounting
holes line up with those of the mounting bars of the 19-inch rack mount cabinet.
• Mount in a location away from direct sunlight and sources of heat. A maximum ambient
temperature of 104º F (40º C) is recommended.
• Route cables away from power lines, fluorescent lighting fixtures, and sources of noise
such as radios, transmitters, and broadband amplifiers
• Ensure that no water or excessive moisture can enter the unit.
• Allow unrestricted airflow around the unit and through the vents on the side of the unit.
A minimum of 1 inch (25.44mm) clearance is recommended.
232-000330-03.fm Page 5 Thursday, April 3, 2003 10:31 AM