Safety Instructions

Page 4
VCCI Statement
FCC part 68 Telecom Information (Model APL10-01F)
Repair Information - According to the FCC, only the modem vendor for the SonicWALL modem
is allowed to service the modem. Contact SonicWALL Technical Support for any repairs
including the modem.
The FCC has established rules which permits this device to be directly connected to the
telephone network. If this device is malfunctioning, it may also cause harm to the telephone
network. This device should be disconnected until the source of the problem is determined and
the repair is made. If this is not done, the telephone company may temporarily disconnect
service.
The telephone company may make changes in its technical operations and procedures. If such
changes affect the compatability or use of this device, the telephone company is required to
give adequate notice of the changes. If the telephone company requests information on the
equipment connected to their lines, inform them of the following:
• Telephone number of the line connected to the device.
• The Ringer Equivalence Number (REN) located on the bottom of the device.
• The device uses an RJ11-type jack.
• The FCC Registration Number located on the bottom of the device.
FCC RF Radiation Exposure Statement (Model APL11-027 and Model APL11-031)
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This eequipment should be installed and operated with a minimum distance of
20 centimeters (7.9 inches) between the radiator(antenna) and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
For more information regarding the above statement, please contact SonicWALL, Inc. at 1160
Bordeaux Dr., Sunnyvale, CA 94089-1209 or 1-408-745-9600.
232-000330-03.fm Page 4 Thursday, April 3, 2003 10:31 AM