Release Notes

Release Notes for the SOHO TZW Internet Security Appliance

Page 3 of 4

trademarks of their respective companies.

P/N 232-000373-00

Rev A 04/03

• Be sure Use Windows to configure my wireless network settings is selected.

• If your TZW SSID name appears in the Available Networks box, select it and then click

Configure. If you do not see it, try clicking Refresh. Please note that if Hide SSID in

Beacon and Block Response to Unspecified SSID are selected on the SOHO TZW,

then you must use the Add button to manually enter the SSID.

WEP Considerations for Windows XP and the SOHO TZW

• If you are using WEP, select Data encryption (WEP enabled) and Network

Authentication (shared mode).

• Clear the The key is provided to me automatically checkbox.

• If using WEP, enter the TZW WEP key in the Network Key and Confirm Network Key

fields.

• If using WEP, Windows XP prior to Service Pack 1 requires you to select the type of key

(alphanumeric, hexadecimal) and the key size (40, 104). Please note that although the

TZW lists different key sizes (64,128) they are actually the same. For this purpose,

40=64 and 104=128. After Service Pack 1, these drop-down boxes are not displayed,

and XP automatically determines the type and size.

• If using WEP, Windows XP prior to Service Pack 1 has a different key index and uses 0-

3 instead of 1-4. The TZW key index uses 1-4. For this purpose, 0=1, 1=2, 2=3, 3=4.

This was resolved in Service Pack 1.

• Click the Association tab and make sure Enable IEEE 802.1x authentication for this

network is not selected.

Additional Regulatory Statement Model APL11-027 and Model APL11-031

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.