User guide

AMPLITUDE: Desired amplitude must be set in order for the Ultrasonic

Processor to be operational. AMPL. displays the amplitude selected e.g. 40%. To

set the amplitude at 40% when the ultrasonics is off, press the AMPL key and the

▲ or ▼ key for a 40% reading on the screen, and then press the

ENTER/REVIEW key.

The screen will display:

Ampl

40 %

The Ultrasonic Processor is now ready for continuous operation. To energize the

ultrasonics, press the START key or the footswitch. To de-energize the ultrasonics, press

the STOP key or release the footswitch.

To increase or decrease the amplitude in small increments when the ultrasonics is on,

depress the AMPL key to display Amplitude Setting on the screen, then depress the ▲ or

▼ key, as required.

NOTE

To clear an erroneous entry press the CLEAR key.

NOTE

The START key and footswitch are mutually exclusive. If the process is initiated

by the START key, the footswitch becomes inoperative. If the process is initiated

by the footswitch, the STOP key becomes inoperative.

Table of Contents