Manual
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
I N S T R U C T I O N M A N U A L • M O D E L G X L P O W E R S U P P LY
45
ANGULAR
DECIMAL
Spare DO4
Bad Part Output
+VDC
1
2
J5-23
J5-21
J5-18
Ext +V_loop
+/- 1/2 DEG.
+/- 1/64
FRACTIONAL
.XXX= +/-0.005
.X= +/-0.030
.XX= +/-0.015
(EXCEPT AS NOTED)
TOLERANCES
CONDITIONS SPECIFIED HEREIN.
MATERIAL
CHK'D
DRAWN BY
DATE
SCALE
NEWTOWN, CT 06470
Good Part Output
2
1
3
2
34
2
1
34
1
4
J5-4
J5-3
J5-22
J5-20
WPS
10-12-05
E-3167
53 CHURCH HILL RD.
DRAWING NO.
43
+24 VDC Unregulated
+V_loop_return
(30 VDC max)
CONFIDENCE, AND SHALL NOT BE DISCLOSED, USED OR DUPLICATED FOR ANY PURPOSE
WHATSOEVER WITHOUT THE PRIOR WRITTEN PERMISSION OF SONICS & MATERIALS INC.,
NEWTOWN, CT. THIS LEGEND SHALL BE MARKED ON ANY REPRODUCTIONS HEREOF IN WHOLE OR
CONFIDENTIAL INFORMATION
Typical 4 Places
RETURN
50 ma maximum
Isolated Supply #2
+24 Unreg
+Vdc (Source Outputs)
100 0hm
typ 4 plcs
G series Digital Outputs (DO)
THE INFORMATION AND DATA CONTAI NED HEREIN IS PROPRIETARY AND IS SUBMITTED IN
IN PA R T. RECEIPT OF THIS DOCUMENT SHALL BE DEEMED TO BE AN ACCEPTA NCE OF THE
SOURCING OUTPUTS TO PLC INPUT DIAGRAM
An external loop supply is required to power the output
circuit (normally provided by the PLC system). Alternatively,
2 isolated, unregulated, 24 VDC supplies are available on
the GX supply (J5 connector). These supplies are NOT
regulated and only rated for 50 ma total.
PLC Input Card - typical 4 places
Supply Ready Output
J5 Mating Connector - AMP # 206437-1
Connector Pins - AMP # 66506-9
The GX digital outputs are optically isolated from the internal circuits. Each transistor is
rated for 30 VDC max @100 ma max; an internal 100 ohm limiting resistor is provided in
each transistor output. Do NOT apply AC voltage!
Source Outputs are the default configuration as shipped from
the factory. They may be switched to "Sink" if desired. See
Section x.xx, "Source/Sink Digital I/O Configuration"
PLC_DIGITAL_IN
COMMON
Go To Top Of Document