Owner manual

20
I N S T R U C T I O N M A N U A L • M O D E L 1 5 9 5 / 1 5 9 6
5. Then, rotate the booster or horn 1/3 of a turn in a clockwise direction and
then repeat step 4.
6. Repeat step 5.
7. Using wire brush, clean stud, then replace securely. Tighten new stud to
the recommended torque specifications on page 13.
NOTE: Machining of
booster / horn may
alter the ability to tune
the component to the
system. System
inoperation may occur.
Go To Top Of Document