DiamondClean Smart
Fig.
Contents Important safeguards_____________________________________________________________ 4 Radio Equipment Directive_________________________________________________________ 5 Introduction_____________________________________________________________________ 6 Your Philips Sonicare (Fig.
English IMPORTANT SAFEGUARDS Warning: READ ALL INSTRUCTIONS BEFORE USE When using electrical products, especially when children are present, basic safety precautions should always be followed, including the following: DANGER To reduce the risk of electrocution: 1 Always place and store the charger at a safe distance from water. 2 Do not reach for a product that has fallen into water. Unplug immediately. 3 Never use a charger with a damaged cord or plug.
English 5 13 Use UL Listed computer, USB Hub or USB duplex receptacle when charging the toothbrush handle in the travel case. 14 When using a computer to recharge the toothbrush handle, the computer should be located away from sources of water (i.e. sink or tub) so as to avoid electrical shock. 15 In order to effectively charge your Philips Sonicare do not place your charger base on a magnetic metal surface.
English Introduction Congratulations on your purchase and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome or via the Philips Sonicare app. Your Philips Sonicare (Fig.
English 7 Brushing modes Your power toothbrush is equipped with 5 different modes to accommodate all your oral care needs (some models come with 4 brushing modes only). The following modes are available: Clean mode 2 3 1 4 6 Clean is a 2-minute mode, recommended to be used with intensity level 3. It gives you a thorough and complete clean and is recommended to be used with the Premium Plaque Control brush head. In order to reach optimal results, follow the instructions below.
English 8 3 1 4 6 2 Next, to take optimal care for your gums, brush the outer and inner surfaces of your upper right back teeth for 20 seconds (segment 1), then brush the outer and inner surfaces of your upper left back teeth for 20 seconds (segment 3). Continue brushing the outer and inner surfaces of your lower right back teeth for 20 seconds (segment 4), followed by another 20 seconds on the outer and inner surfaces of your lower left back teeth (segment 6).
English 9 Intensity settings Your power toothbrush gives you the option to choose between 3 different intensity levels: low, medium and high. Based on the brush head you attach, the intensity will be selected automatically. If you wish to change to a different intensity, you can do so by pressing the mode/intensity button while brushing. For optimal results it is recommended to use the automatically selected intensity. The intensity cannot be changed as long as the handle is powered off or paused.
English 4 Place the toothbrush bristles against the teeth at a slight angle (45 degrees), pressing firmly to make the bristles reach the gumline or slightly beneath the gumline. A change in vibration (and a slight change in sound) and activation of the light ring alert you when you apply too much pressure while brushing. Note: Keep the center of the brush in contact with the teeth at all times. 5 Press the power on/off button to switch on the Philips Sonicare.
English 11 a. App Your Philips Sonicare is Bluetooth enabled and allows you to achieve superior oral health care with the Philips Sonicare app. Using the Philips Sonicare app will help you to improve your oral health care habits. It gives you real-time feedback while brushing, informs you if you missed any spots when brushing, tracks your brushing behavior over time and provides useful tips and tricks for your healthiest mouth ever.
English 12 c. Brush head replacement reminder Your Philips Sonicare is equipped with a smart feature that tracks the wear of your brush head. Depending on the pressure you apply and the amount of time used, the brush head replacement reminder light reminds you to change your brush head. It is important to change your brush head in time in order to guarantee the best cleaning & care of your teeth. When the amber brush head replacement light starts blinking, you should replace your brush head.
English 13 3 Easy start is disabled by holding the mode/intensity button and by pressing the power button once while on the charger. The handle will beep once to confirm it is disabled. Note: Using the Easy-start feature beyond the initial rampup period is not recommended and reduces Philips Sonicare effectiveness in removing plaque. Note: Each of the first 14 brushings must be at least 1 minute in length to properly move through the Easy-start ramp-up cycle.
English 4 The battery indication flashes white until your toothbrush is fully charged. Important: The wall adapter must be a safe extra low voltage source, compatible with the electrical ratings marked on the device. Important: Only toothbrush models HX993W, HX993B, HX993P, HX993S, HX993L can be charged in the travel case. Other products and batteries are not compatible with the travel case. Note: It takes at least 24 hours to fully charge your Philips Sonicare.
English 15 Brush head 1 Rinse the brush head and bristles after each use. 2 Remove the brush head from the handle and rinse the brush head connection with warm water at least once a week. Charger and travel case 1 Unplug the charger and travel case before you clean it. 2 Use a damp cloth to wipe the surface of the charger and travel case. Glass 1 Clean the glass with water and some mild soap. 2 Dry the glass with a soft towel. The glass is dishwasher-safe.
English Removing the rechargeable battery Warning: Only remove the rechargeable battery when you discard the appliance. Make sure the battery is completely empty when you remove it. To remove the rechargeable battery, you need a towel or cloth, a hammer and a flat-head (standard) screwdriver. Observe basic safety precautions when you follow the procedure outlined below. Be sure to protect your eyes, hands, fingers, and the surface on which you work.
English 17 6 Remove the rubber battery cover. 7 Wedge the screwdriver between the battery and the black frame at the bottom of the internal components. Then pry the screwdriver away from the battery to break the bottom of the black frame. 8 Insert the screwdriver between the bottom of the battery and the black frame to break the metal tab connecting the battery to the green printed circuit board. This will release the bottom end of the battery from the frame.
English FCC Compliance Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1 This device may not cause harmful interference, and 2 This device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by Philips Oral Healthcare could void the user’s authority to operate the equipment.
English 19 LIMITATION OF REMEDIES IN NO EVENT SHALL PHILIPS OR ANY OF ITS AFFILIATED OR SUBSIDIARY COMPANIES BE LIABLE FOR ANY SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES BASED UPON BREACH OF WARRANTY, BREACH OF CONTRACT, NEGLIGENCE, TORT, OR ANY OTHER LEGAL THEORY. SUCH DAMAGES INCLUDE, WITHOUT LIMITATION, LOSS OF SAVINGS OR REVENUE; LOSS OF PROFIT; LOSS OF USE; THE CLAIMS OF THIRD PARTIES INCLUDING, WITHOUT LIMITATION, DENTISTS AND DENTAL HYGIENISTS; AND COST OF ANY SUBSTITUTE EQUIPMENT OR SERVICES.
www.philips.com/Sonicare ©2018 Koninklijke Philips N.V. (KPNV). All rights reserved. Philips and the Philips shield are trademarks of KPNV. Sonicare and the Sonicare logo are trademarks of Philips Oral Healthcare, LLC and/or KPNV. 4235.021.1899.
