User manual

The Quadpacer on this model has been activated.
To deactivate or reactivate the Quadpacer:
1 Place the handle with a brush head attached on
the plugged-in charger or sanitiser
2 To deactivate the Quadpacer: press and hold
the Personalised Brushing button for
5 seconds. You hear 1 beep to indicate that
the Quadpacer has been deactivated.
, To reactivate the Quadpacer: press and hold
the Personalised Brushing button for 5 seconds
until you hear 2 beeps. This indicates that the
Quadpacer is active again.
Note: The Quadpacer cannot be deactivated on the
pre-programmed Go Care and Max Care brushing
routines.
Cord wrap on deluxe charger
(specic types only)
If your model includes the deluxe charger cover and
base, the travel charger is pre-installed inside the
cover. If you want to shorten the mains cord, you
can store excess cord in the cord-wrap feature built
into the charger base.
1 To separate the charger cover from the
charger base, press the two grey snap bars on
the charger base and pull the white charger
cover upwards.
2 Wrap excess cord around the grey charger
base as shown in the picture. Be sure to wrap
the cord on the inside of the two snap levers.
ENGLISH 15