Safety Instructions

C-Shape
7
It is very important to check the training wheel connection
to the bicycle. Failure to properly tighten may cause the
training wheel to dislodge and cause the child to lose
control and fall.
Training wheels should be checked before every use to
not over-worn, cracked or otherwise damaged.
Damaged training wheels should be replaced before
any future use.
Attaching training wheel brace to bicycle
Remove the axle nut and washer from the rear wheel axle. Place the brace stabilizer washer
out. Next, place the C-shaped wheel brace onto the axle and replace the washer and axle nut.
Tighten the axle nut securely, making sure that the wheel brace stays in the proper vertical
position. The elongated hole on the wheel brace allows the training wheel height to be
It is important that any child using stabilisers is fully
supervised. As they provide extra width, more contact
surfaces with the ground and are behind the child, they can
increase the risk of a collision, especially on uneven ground.
Any collision can render the bicycle unsafe and can lead to
the child losing control and falling.
Brace stabilizer
washer
c-shaped
wheel brace
Axle nut
Inner axle
Training wheel
Inner axle nut
DO NOT
REMOVE