Safety Instructions

Adjustable spanner

Allen keys (provided)

Pliers with cable cutting ability

Philips head screwdriver

Square-bladed screwdriver

Tools required

Getting started

Open the carton from the top and remove the bicycle. Remove the straps and protective

wrapping from the bicycle. Inspect the bicycle and all accessories and parts for possible

shortages. It is recommended that the threads and all moving parts in the parts package be

lubricated prior to installation. Do not discard packing materials until assembly is complete to

ensure that no required parts are accidentally discarded.

Handlebars

Remove the protective cap from the stem wedge and loosen the stem bolt using the Allen key.

Some models may use a hexagonal bolt instead of an Allen key bolt.

Place the handlebar stem into the head tube, observing the minimum insertion mark on the

handlebar stem and ensuring that all cables are free of tangles.

Check that the fork and the handlebar are facing forward, and that they are properly aligned

with the front wheel.

Tighten the stem bolt 2 turns. Rotate the handlebar to the desired position in relation to the

front wheel.

Tighten stem bolt until the bar is fully secured. Check that the stem binder bolt is tight and secure.

The handlebar must be inserted so that the minimum insertion

mark cannot be seen. Over tightening the stem bolt or

headset assembly may cause damage to the bicycle

and/or injury to the rider.

Assembly

Minimum Insertion

Marks

Stem Bolt

Head T ube

Binder Bolt

Top Nut

W edge

It is recommend that you consult a bicycle specialist if you have

ANY doubts or concerns as to your experience or ability to

properly assemble, repair, or maintain your bicycle.