Safety Instructions

Side Pull

Brakes

When assembling or adjusting the brakes, make

sure the cable anchor is tight. Failure to securely

tighten the nut could result in brake failure and

personal injury.

Cable

Adjusting

Barrel

Center Bolt

Cable

Anchor

Nut

Brake

Shoe

Fixing Nut

in Back

Brake

Arm

Loosen the cable anchor nut and thread the brake cable through it.

Tighten the nut by hand until it holds the cable in place.

Squeeze the brake arms together against the rim of the wheel.

Loosen the nuts on the brake shoes and turn until they match the angle of the rim.

Tighten the nuts securely.

Pull down on the end of the brake cable with pliers, hold taut and securely tighten the

cable anchor nut.

Spin the wheel, the brake shoes should not contact the rim at any point and should be an

equal distance from the rim on both sides.

Make sure all nuts and bolts are securely tightened.

Brake adjustment