Safety Instructions

1. Brakes
- Ensure front and rear brakes work properly.
- Ensure brake shoe pads are not over worn and are correctly positioned in relation to the rims.
- Ensure brake control cables are lubricated, correctly adjusted and display no obvious wear.
- Ensure brake control levers are lubricated and tightly secured to the handlebar.
2. Wheels and tyres
tyre sidewall.
- Ensure tyres have tread and have no bulges or excessive wear.
- Ensure rims run true and have no obvious wobbles or kinks.
- Ensure all wheel spokes are tight and not broken.
- Check that axle nuts are tight.
3. Steering
- Ensure handlebar and stem are correctly adjusted and tightened, and allow proper steering.
- Ensure that the handlebars are set correctly in relation to the forks and the direction of travel.
- Check that the headset locking mechanism is properly adjusted and tightened.
4. Chain
- Ensure chain is oiled, clean and runs smoothly.
- Extra care is required in wet or dusty conditions.
5. Bearings
- Ensure all bearings are lubricated, run freely and display no excess movement, grinding
or rattling.
6. Cranks and pedals
- Ensure pedals are securely tightened to the cranks.
- Ensure cranks are securely tightened to the axle and are not bent.
7. Frame and Fork
- Check that the frame and fork are not bent or broken.
- If either are bent or broken, they should be replaced.
8. Accessories
- Ensure the rider is wearing a helmet.
10
SAFETY CHECKLIST
Before every ride, it is important to carry out the following safety checks: