Safety Instructions

This bicycle is supplied with one front (white), one rear (red) two wheel (white) and four

and mountings for signs of wear or damage. If damage is found, replace immediately.

First insert one washer onto the hex bolt and insert hex bolt through the

onto the bolt and thread a hex nut onto the bolt behind the fork.

position. See diagram to the right.

see the top diagram. Next, remove the clamp screw and open the

the handlebar or seatpost. If the clamp is too loose,

insert the shim inside of the clamp. Tighten the

see the diagram below. Finally, adjust the

is upright and facing away from the bike.