User Guide

Installing the Dongle 7
Installing the Dongle
The included dongle supplies preset algorithms in response to requests from Scenarist.
Scenarist must receive these algorithms from the dongle or it will not run.
To install the dongle:
1 Power down your computer.
2 Remove the printer cable (if applicable) from the parallel port.
3 Attach the dongle to the parallel port and attach the printer cable (if applicable) to the
dongle.
4 Turn on your computer.
Note: If you have an existing Sonic dongle connected to your parallel port, you can use it
with Scenarist. It is not possible to connect two Sonic dongles to your computer’s parallel
port. To get a Scenarist Activator Code that will work with your existing dongle, contact
Sonic Support (http://support.sonic.com/).
Installing the Software
This section documents how to install your Scenarist software. It includes the following
topics:
• “Logging On in Administrator Mode” on page 8
• “Uninstalling an Earlier Version of Scenarist” on page 8
• “Installing and Activating Scenarist” on page 9